Upgrade

The main components of the XCC are updated by the XPhone server. However, if something changes in the operating system or the satellite bridge, the satellite must also be updated. The XCC settings (also SIP gateways and lines) are included in the XPhone Server, so replacing the virtual machine or only the virtual hard disk is sufficient.

Deploy a new virtual machine

You can create a completely new virtual machine. Follow these instructions for action:

• Provision a new virtual machine in Hyper-V or VM-Ware (e.g. vSphere).

• Start the virtual machine.

• Disable all SIP gateways and the XCC.

• stop the satellite to be exchanged.

• Remove the satellite just stopped.

• Configure a fixed IP address for the new satellite.

• Create a new satellite.

• Configure in XCC the Linux satellite you just created.

• Enable all SIP gateways and the XCC.

• Delete the old virtual machine.

Replace the virtual hard disk

You can also replace only the virtual hard disk. Follow these instructions:

• Deaktivieren Sie alle SIP Gateways.

• Deaktivieren den XCC und stellen auf den lokalen XCC um.

• stop the satellite to be exchanged.

• Remove the satellite just stopped.

• Fahren Sie die virtuelle Maschine herunter und tauschen in der virtuellen Maschine Hyper-V oder VM-Ware (z.B. vSphere) nur die virtuelle Festplatte aus.

• Start the virtual machine.

• Configure a fixed IP address for the new satellite.

• Create a new satellite.

• Configure in XCC the Linux satellite you just created.

• Enable all SIP gateways and the XCC.

• Delete the old virtual hard drive.

Have you found an mistake on this page?

Please send us a hint about this error by mail to doku@c4b.de. Thank you very much!